KIDES Extrusion

Ref: 18031ANODA

Fixtures made of KIDES series extrusions are made for indoor and outdoor applications.

  • Ability to create a line of light
  • IP54 protection class without the need for sealing compounds
  • Large chamber for power supply, electronic components and electrical connection
  • Simple design
Silver anodized
Technical specification

- for construction of splash-proof wall lamps with high light efficiency


- using a mounting strip fastened with screws appropriately selected for the mounting surface

Additional information

- wide range of end caps
- for outdoor and indoor applications
- good heat dissipation
- IP54 ingress protection only with the KIDES cap
- spece for LED strip: 1.94" / 49.5 mm

Fixtures made of KIDES series extrusions are made for indoor and outdoor applications. They are resistant to rain and snow, but are not IP68 rated (they cannot be immersed in water). They should be mounted in accordance with the guidelines contained in the manual. When used outdoors, use only KIDES series end caps. When used indoors, the above-mentioned caps can be used, or simplified caps from KIDESIN series for indoor applications.

KIDES is made of TEKIDES mounting extrusion and OKIDES extrusion. This extrusion has a compartment for the selected power supplies. In this section, HSP47 covers are applied. Following the mounting of TEKIDES extrusion on the surface and after power supply cable has been installed, click-mount OKIDES extrusion. Finally, end caps are mounted. Details of installation and a list of necessary components are contained in the manual.

Turn off LED lights during peak day light hours in outdoor applications to avoid excessive heat buildup which will result in diminished LED life.

Ref. nr. surface finish available lengths
18031ANODA_1 Silver anodized
18031ANODA_2 Silver anodized
Technical drawing