Introducing the LARKO-50 LED Lighting Extrusion
The new LARKO-50 LED lighting extrusion is perfect for creating serviceable straight and sectioned light fixtures to be mounted in drywall. It can be used to create a line of light and does not require plastering and painting the surface after install.
- This LED extrusion is designed for up to four (0.39″ / 10mm) wide LED strips
- The cover is evenly illuminated with four LED strips, with fewer strips shadows appear on the cover
- LARKO-50 extrusion is equipped with ZM sockets on the inside and outside
- note – (ZM connectors used to connect extrusions lengthwise are easily accessible even after mounting the extrusion in the ceiling, external sockets are used to mount KMA springs)
- The recommended number of springs (assembled in pairs) depending on the length of the extrusion:
- The groove cut out in the drywall to accommodate the extrusion should be (2.0″-2.2″ / 51mm-56mm) wide
- When mounted in double drywall, the extrusion does not interfere with the structure.
See spec sheets, installation instructions, and more information about the LARKO-50 Extrusion by clicking here.
Introducing the KOZUS-50 LED Lighting Extrusion
The KOZUS-50 extrusion can also be used for creating serviceable straight and sectioned LED lighting fixtures, mounted in drywall. The aluminum extrusion is can be concealed, and the extrusion will not interfere with a structure made of 5/8 inch drywall.
- This LED extrusion is used to create a line of light flush with the surface of walls and ceilings
- It is assembled in the groove with mounting adhesive and has fastening wings covered with gypsum plaster
- The protective insert TECH-50 ensures that the extrusion slot remains wide enough for the snap-in cover (its use is necessary during mounting and finishing works)
- It is designed for up to four (0.39″ / 10mm) wide LED strips
- The cover is evenly illuminated with four LED strips, with fewer strips shadows appear on the cover
- The KOZUS-50 extrusion is equipped with ZM sockets (ZM Connectors are used to connect extrusions lengthwise, they are easily accessible even after mounting the extrusion in the ceiling)
- The groove cut out in the drywall to accommodate the extrusion should be (2.0″-2.2″ / 51mm-56mm) wide
See spec sheets, installation instructions, and more information about the KOZUS-50 LED lighting extrusion by clicking here.
